While the conventional method works well and has been around a long time it has outgrown the industry and is too costly to use. After working in a very busy environment for the past 15 years the aim was simply to reduce make ready times and increase production. The ease of use of SpeedPin eliminates the tedious set up of the conventional method and cost.

Go to “how it works” section

Yes, it can be added into any CAD system.

SpeedPin is easily fitted to tooling. There are pre-lasered
holes provided by your die maker. Our “Fit & Strip” method
means no training is required.

• There are a number of factors to this issue
• Ensure the tooling is in good condition
• Ensure it is not over nicked
• Cutting is all patched up

This durable product has been tested to 3,000,000 sheets

• Massive savings for each and every user
• Dramatically reduces make ready time by 60 – 80%
• Dedicated to each job – the more you use, the more you save
• Greatly increases production – efficiently strips waste
• Jobs can be run at top speed
• Radically reduces machine downtime due to its simple “fit and strip” method
• A robustly durable product, tested to a run of 3,000,000 sheets
• The bottom stripping unit becomes redundant so less machine maintenance, saving even more on yearly maintenance budgets
• No need for bottom pins, costing €11-€13 each, i.e. 50 x €13 = saving of €650

While SpeedPin can be added manually we recommend setting a new female
stripping board. You benefit from precise positioning and use the least amount of pins

We recommend you keep a stock of SpeedPins , as will your die maker.
Therefore you need never run out.